Sealoflex Professional

Accelerated Weathering (SABS182) : no change after 2000 hours

12 months in original, unopened container.

Store in properly closed, sealed and undamaged packaging in dry conditions at temperatures between +5ºC and 30ºC. Protect from direct sunlight.

1.2 ± 0.05

Primer: Not normally required.  On porous surfaces use Sealobond® Primer.
Coating: Sealoflex® Professional 1 – 2 coats

1.15 joules

1 - 2 mm thick

Min. 5°C – Max. 35°C.

<80%

Substrate temperature, must always be at least 3°C above the measured dew point.

Min. 5°C – Max. 30°C.

<10%

Touch Dry: 2- 3 hours depending upon ambient conditions

~ 1.0 litre per m² per coat. Two coats recommended

The surface, must be dry and free of all contaminants, such as oils, grease, coatings and surface treatments etc.
Weak concrete should be removed and surface defects such as honeycombed areas, blowholes and voids must be fully exposed.
Repairs to substrate, filling of blowholes/voids and surface levelling, should be carried out using the appropriate product from the Sika^® MonoTop^®, Sikadur^® range of materials.

All surfaces must be clean, sound, dry and properly cured. Remove all loose materials mechanically, with a wire brush, or by water or sand blasting.  Metal surfaces should be free of rust.
For wooden roofs and, in particular T & G boarded roofs, the entire area to be waterproofed, should be covered with 2-ply roofing felt, kept in position by galvanised clout nails and/or a suitable adhesive.

Mix contents thoroughly prior to application

Step 1 Apply suitable primer if required.

Step 2 Apply a generous base coat of Sealoflex® Professional evenly by brush, roller or soft broom and allow drying for at least 4 hours or until touch dry.

Step 3 When touch dry, apply a top coat evenly and at right angles to the base coat. Additional coats may be applied as necessary.

Remove uncured Sealoflex® Professional with water. Cured material can only be removed mechanically.